AVP Synthesizer MBS-100 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Синтезатор AVP Synthesizer MBS-100. AVP Synthesizer MBS-100 8 сторінок. Monophonic

MIDI Input: Connect the MIDI OUT port of the sequencer or MIDI keyboard (or

other MIDI transmitting device) to the MBS-100 MIDI IN port.

MIDI THRU: this port is used in order to sequence other units along with MBS-

100.

Overview of controls

MBS-100 structure consists of classical analog subtractive synthesizer module

sections: OSC, VCF, VCA, LFO and ADSR.

OSC Section

The TUNE controls allow you to adjust the pitch of MBS-100 to other instruments,

as well as for the classical detuning of the oscillators. Adjustment can be made in

the range of

±2

semitones.

You can adjust the volume levels of the oscillators with the LEVEL controls.

The SYNC button enables the synchronization of the two oscillators, wherein the

TUNE knobs will be turned off and the synth will automatically adjust by the

tempered scale.

Buttons OSC1 and OSC2 enable to choose one of the four waveforms: saw,

square, pulse 1 and pulse 2. When the waveforms "saw" or "square" are selected,

the LED indicators with the corresponding symbols are lit constantly.

When waveforms "pulse 1" or "pulse 2" are selected, the same LED indicators will

be flashing.

OCT button selects the octave of the second oscillator. When it is set at «0» - the

second oscillator is tuned in unison with the first oscillator, when it is set to «-»

there is a shift by an octave down, "+" shift by an octave up.

MIDI button selects the channel of the MBS-100 (see below).

VELO button enables/disables the Velocity function that controls the filter

(CUTOFF) (see below).

ENTER button enables MBS-100 to switch to the operating mode from the setup

mode.

VCF Section

CUTOFF and RESO controls are used to shape the filter frequency and resonance,

respectively.

ATTACK, DECAY, SUSTAIN and RELEASE controls are used to adjust the filter

envelope, ADSR LEVEL allows to set the amount of envelope level applied to the

filter.