Billib Mantel & Wall Clocks Інструкція та посібник з догляду - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція та посібник з догляду для Годинник Billib Mantel & Wall Clocks. Billib Mantel & Wall Clocks 10 сторінок.

Друкувати сторінку

Billib

5. Hang Pendulum (if available)

Some pendulum bobs have a protective plastic

coating which should be removed. Carefully

hook the pendulum onto the pendulum

hanger as diag rammed (Fig. 4). Take care

not to twist the hanger , which may cause the

delicate suspension spring to break.

Draw pendulum over to one side of the case

and release it. As pendulum slows down to its

normal swing, the movement will automatically

adjust to the proper beat. The sound should

be an even tempo: Tick—Tick—Tick—Tick. If

the sound is uneven the beat is out of

adjustment. Stop pendulum and restart the

swing. If the beat is impro ved, but not yet even,

repeat the process but pull the pendulum to

the other side of the case (Fig. 5).

6. Wind Clock

NOTE: Springs may already be w ound.

key and fully wind each location in a

clockwise direction. The centre is for time ,

the right for quarter chimes, and the left f or

hour strike (Fig. 6).

Wind your clock at the same time each w eek

for accurate timekeeping.

7. Set Time

DO NOT move the clock hands while chimes

are playing.

To set your clock, move the minutehand

cloc kwise, the chimes should not

play. If f or some reason the chimes should

begin to play when setting the clock, pause

until they complete themselves bef ore

continuing. Wait until chimes stop, and tur n

the minute hand counter clockwise to the

desired time (Fig. 7).

DO NO T move the hour hand, it will

automatically adjust as the minute hand

is turned.

NOTE: If hour hand does not coincide with

chime, see Troubleshooting page 15.

Fig. 4

Top of

Pendulum

Fig. 5

Insert

Fig. 6

Fig. 7

BilliB

Fig. 8

Pendulum

Hanger

Chime Selector

Positions

Fig. 9

Gap Required

Chime

Rod

Fig. 10

Fig. 11

Regulating

Nut

Turn Down

To Slow Time

8. Select Chimes

The movement pla ys the Westminster

Chimes only, or a selection of Westminster,

St. Michael 's and Whittington Chimes. The

chimes can be silenced by moving the lever

located at the 9:00 or 3:00 position (Fig. 8).

9. Adjust Chimes

If the hammers do not str i ke the rods correctly ,

bend the hammer shafts slightly . while at rest,

the hammer heads should be approximately

" to ¹⁄₈" from the rods (Fig.9).

¹⁄

Chime

Hammer

10.Adjust/Regulate Clock

Without Pendulum:

Bend

Here

Turn the small adjustment screw shown in

Fig. 10 to adjust time . A complete turn of the

screw will change the time keeping b y one

minute in 24 hours . If your clock r uns fast,

turn the screw clockwise. If the clock runs

Adjustment Screw

slow, turn the screw counter clockwise.

Speed

Clock

With Pendulum:

Hold pendulum securely while adjusting the

regulating nut.

Slow

DO NOT allow pendulum to twist. This may

Clock

damage the suspension spring (Fig. 17).

One complete turn of the regulating n ut will affect

approximately one half minute in 24 hour .

Seasonal temper ature changes may require

adjustments to the regulating nut (Fig. 11).

Turn U p To

Speed Time