AVPro Edge AC-MXNET-10G-SW12C Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання AVPro Edge AC-MXNET-10G-SW12C. AVPro Edge AC-MXNET-10G-SW12C 8 сторінок. The mxnet 10g sdvoe ecosystem

3: Connect the Transceivers to the Network Switch
Once the transceiver modes have been selected and the port types have been configured for
Category or fiber cabling, connect the transceivers to the network switch.
4: Connect the Transceivers to their HDMI devices
Connect the HDMI source devices to the HDMI IN port on the encoders, and the HDMI output devices
to the HDMI OUT port on the decoders.
(Rear Panel)
AC-MXNET-10G-TCVR
On Encoders: Connect to the HDMI
source device with an HDMI cable
Note:
When the transceiver is set to encoder mode, the HDMI OUT port functions as an HDMI Loop Out port.
5: Connect the CBOX to the Network Switch
Connect the SDVoE port on the CBOX
1
to a 10G SFP+ port on the network
switch (or an SFP28 port on the AC-
MXNET-10G-SW12C).
Connect the PORT 6 (PoE) port to the
2
LAN, router, or third party control
system for power and/or access to the
Mentor interface.
*If PoE is unavailable, use the DC/12V
3
power inlet to locally power the CBOX
by connecting it to an electrical outlet.
On Decoders: Connect to the HDMI
output device with an HDMI cable
1
*
3
Page 4 of 8
2
MXNET 10G SDVoE
®
Quick Start Guide