Dell 3250 Посібник з експлуатації - Сторінка 29

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Робочий стіл Dell 3250. Dell 3250 37 сторінок. Product guide (.pdf)
Також для Dell 3250: Інформаційне оновлення (32 сторінок), Посібник користувача (39 сторінок), Посібник користувача (39 сторінок), Посібник із швидкого старту (2 сторінок)

Intel® Server Platform SR870BH2

The BIOS and BMC maintain failure history for each processor in nonvolatile storage. This

history is used to store a processor's track record. Once a processor is marked "failed," it

remains "failed" until the user forces the system to retest the processor by entering BIOS Setup

and selecting the "Retest processors" option. The BIOS reminds the user about a previous

processor failure during each boot cycle until all processors have been retested and

successfully passed the FRB tests or AP initialization.

It is possible for all the processors in the system to be marked bad. If all the processors are bad,

the system, in final desperation mode, does not alter the BSP and attempts to boot from the

original BSP. Again, error messages are displayed on the console and errors are logged in the

SEL against a failing or non-healthy processor, with the exception of the single processor case,

where the error will be logged, but failing desperation mode, there will be no video display.

If the user replaces a processor that has been marked bad by the system, the system must be

informed about this change by running BIOS Setup and selecting the processor retest option.

User selection of the Retest Processor option, in BIOS Setup, results in the BIOS and BMC

clearing the Processor failure history from their respective non-volatile storage.

There are three possible states for each processor slot:

•

Processor installed (status only; indicates processor has passed BIOS POST).

•

Processor failed. The processor may have failed FRB-2, FRB-3, or BIST, and it has

been disabled.

•

Processor not installed (status only, indicates the processor slot has no processor in it).

8.5.5

FRB Failure Isolation

The issue may be caused by add-in adapter resource contention causing the timer to expire and

trigger an FRB, the system should be brought to a minimum config to eliminate variables and

restarted w/processor re-test (Enter BIOS / startup options). If the failure persists Refer to

"Processor" in Debug Methodology and failure Isolation section.

Revision 1.1

Debug Methodology and Failure Isolation