Allied Telesis AR440S Примітка до випуску - Сторінка 4
Переглянути онлайн або завантажити pdf Примітка до випуску для Програмне забезпечення Allied Telesis AR440S. Allied Telesis AR440S 14 сторінок. 54266-02 patch release note
Друкувати сторінку
4
Features in 54266-02
PCR: 40466
Module: ISAKMP
When the router was the initiator in an ISAKMP Quick mode exchange with
a PC running Windows 2000 or Windows XP, the IPSEC communication
would not establish successfully. This was because the Windows PC set the
commit bit in the exchange, but sent the CONNECTED Notify payload in
the Quick mode exchange. However, the router was waiting for an
Informational Exchange containing a Notify payload (with the
CONNECTED Notify Message) as specified by RFC 2408. Because an
Informational message was expected, the device did not process the Quick
mode CONNECTED message, and so the exchange was never committed.
Although this behaviour is described as "not required by the IKE standard"
[http://www.microsoft.com/technet/community/columns/cableguy/
cg0602.mspx], the device will now process CONNECTED messages
received in Quick mode exchanges, to allow interoperability with other
vendors.
PCR: 40470
Module: BGP
When BGP redistributed routes, locally imported routes were selected
rather than peer learnt routes. This issue has been resolved.
PCR: 40479
Module: OSPF
For OSPF-originated routes, it was possible for a route to be deleted from
the IP routing table, but still be referenced by OSPF. This could cause a
router reboot when later generating a summary LSA that contained the old
route. This occurred using the reset ip command. This issue has been
resolved.
PCR: 40496
Module: DHCP
When DHCP is enabled, it reclaims IP addresses at router startup to
determine if the addresses are in use or not. If, during this process, DHCP
was disabled then re-enabled, the router would not attempt to reclaim the
remaining IP address ranges. This would lead to the rejection of DHCP
requests for IP addresses that were still being reclaimed. This issue has been
resolved.
PCR: 40516
Module: DHCP
While initialising a range, the router acting as a DHCP server may release a
dynamic entry incorrectly. This issue has been resolved.
PCR: 40520
Module: DVMRP
Multicast data could not flow from PIM to DVMRP on a PIM/DVMRP
border router. This issue has been resolved.
PCR: 40530
Module: IPG
When both Load Balancer and Firewall were configured, the very first TCP
session was established after rebooting. Subsequent TCP session startup
packets may have been routed out to an incorrect interface causing sessions
to not be established. This issue has been resolved.
Patch Release Note
Level: 2
Level: 2
Level: 2
Level: 2
Level: 2
Level: 2
Level: 2
Patch 54266-02
C613-10417-00 Rev B