Allied Telesis AR440S Примітка до випуску - Сторінка 5

Переглянути онлайн або завантажити pdf Примітка до випуску для Програмне забезпечення Allied Telesis AR440S. Allied Telesis AR440S 14 сторінок. 54266-02 patch release note

Друкувати сторінку

Allied Telesis AR440S Примітка до випуску

Patch 54266-02

C613-10417-00 Rev B

PCR: 40537

Module: BGP

When the status of an interface changed, the BGP revaluation of IP routes

for redistribution (via the add bgp import or add bgp network commands)

was incorrect. This gave inconsistent BGP route tables depending on the

order of events. This issue has been resolved.

PCR: 40549

Module: SWI

The receipt of two IP packets whose destination IP addresses were subnet

addresses caused the router to reboot. This issue has been resolved.

PCR: 40560

Module: DHCP

A router reboot could occur when the DHCP server checked whether an IP

address was being used by other hosts, for example, after processing a

DHCP Discover message. This issue occurred if probe=arp was specified

for the DHCP range, and if DHCP had been disabled and then enabled. This

issue has now been resolved.

PCR: 40573

Module: LOG

If the log module was configured to store a very large number of messages

(for example, more than 3000 messages), a watchdog timeout could occur

when the show debug command was executed. This issue has been

resolved.

PCR: 40587

Module: IPG, PIM, DVMRP

When doing Layer 3 IP multicast routing, the router would flood traffic to

all ports in the downstream VLAN. This issue has been resolved, and now

the router will do the portmap calculation based on IGMP, PIM-SM, PIM-

DM, DVMRP neighbour information, and forward the multicast traffic to

the calculated portmap.

PCR: 40588

Module: PPP, CC

A toplogy change in a network could cause a router to attempt to activate

an ISDN call configured with direction=in when the call was already

activated. In this situation, the call was failing, and the PPP link over the call

would not come open. This issue has now been resolved.

PCR: 40592

Module: BOOTP

If a timed-out ARP entry was renewed by BOOTP, the new entry be created

with no port association. This issue has been resolved.

PCR: 40599

Module: FIREWALL

The add firewall apprule command did not correctly accept the port

parameter, so the port value was set to zero. This issue has been resolved,

and the port value is stored correctly.

PCR: 40612

Module: IPG, DNS Relay

There was an issue in DNS Relay that resulted in a memory leak. The leak

occurred when a response to a relayed DNS request contained an

authoritative nameserver or additional information and the DNS request

was forwarded to one of those servers. There was also an issue whereby

DNS queries handled by DNS Relay would sometime result is corrupt

entries in the DNS cache. These issues have been resolved.

Level: 2