Dell Dimension 2200 Посібник із заміни - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із заміни для Сервер Dell Dimension 2200. Dell Dimension 2200 9 сторінок. Vga card installation instructions
Також для Dell Dimension 2200: Інструкція з монтажу (1 сторінок), Посібник (50 сторінок)
Друкувати сторінку
4
Dell PowerEdge 2200 Systems Microprocessor Replacement
microprocessor
retention bracket
Figure 2. Removing a Terminator Card
a. Remove the terminator-card retention bracket cover that holds the termi-
nator card in place. Using the thumb and forefinger of each hand, pinch
the vertical tabs at each end of the cover, and then lift the cover straight
up.
b. Remove the terminator card. Holding the card by its edges, lift the card
straight up from the microprocessor retention bracket.
5. If you are upgrading an existing microprocessor, remove the micro-
processor module as follows.
WARNING: The microprocessor-module heat sink can get extremely
hot. Be sure that it has had sufficient time to cool before proceeding.
a. Using a
-inch nut driver, remove the two hexagonal screws securing
1/4
the microprocessor module to the system board assembly (see Figure 3).
terminator
card
terminator-card
retention bracket cover
tabs (2)