Dell Dimension 2200 교체 매뉴얼 - 페이지 4

{카테고리_이름} Dell Dimension 2200에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Dimension 2200 9 페이지. Vga card installation instructions
Dell Dimension 2200에 대해서도 마찬가지입니다: 설치 지침 (1 페이지), 매뉴얼 (50 페이지)

페이지 인쇄
Dell Dimension 2200 교체 매뉴얼
4
Dell PowerEdge 2200 Systems Microprocessor Replacement
microprocessor
retention bracket
Figure 2. Removing a Terminator Card
a. Remove the terminator-card retention bracket cover that holds the termi-
nator card in place. Using the thumb and forefinger of each hand, pinch
the vertical tabs at each end of the cover, and then lift the cover straight
up.
b. Remove the terminator card. Holding the card by its edges, lift the card
straight up from the microprocessor retention bracket.
5. If you are upgrading an existing microprocessor, remove the micro-
processor module as follows.
WARNING: The microprocessor-module heat sink can get extremely
hot. Be sure that it has had sufficient time to cool before proceeding.
a. Using a
-inch nut driver, remove the two hexagonal screws securing
1/4
the microprocessor module to the system board assembly (see Figure 3).
terminator
card
terminator-card
retention bracket cover
tabs (2)