Dell Force10 MXL Blade Посібник - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник для Перемикач Dell Force10 MXL Blade. Dell Force10 MXL Blade 27 сторінок. 10/40gbe blade switches
Також для Dell Force10 MXL Blade: Посібник для початківців (38 сторінок), Примітка до заявки (6 сторінок), Технічні характеристики (2 сторінок)

Stacking Dell Force10 MXL 10/40G Switches

=============================================

Type

----------------------------------------------------------------

Stack-unit 0 FLASH BOOT

Stack-unit 1 FLASH BOOT

Stack-unit 2 FLASH BOOT

Stack-unit 3 FLASH BOOT

Stack-unit 4 FLASH BOOT

Stack-unit 5 FLASH BOOT

5. Configure the stack to boot to the new firmware file (B in this example), then save the

configuration.

FTOS#config

FTOS(conf)#boot system stack-unit all primary system b:

FTOS(conf)#exit

FTOS#copy running-config startup-config

File with same name already exist.

Proceed to copy the file [confirm yes/no]: yes

11910 bytes successfully copied

Synchronizing data to peer Stack-unit

!!!!

...

6. Reload the stack to activate the new firmware.

FTOS#reload

Proceed with reload [confirm yes/no]: yes

Wait for reload to complete. This may take a few minutes longer than upgrading a single

switch.

7. Verify the new firmware is active on all stack members.

FTOS#show boot system stack-unit all

Current system image information in the system:

=============================================

Type

----------------------------------------------------------------

Stack-unit 0 FLASH BOOT

Stack-unit 1 FLASH BOOT

Stack-unit 2 FLASH BOOT

Stack-unit 3 FLASH BOOT

Stack-unit 4 FLASH BOOT

Stack-unit 5 FLASH BOOT

Boot Type

8.3.15.0[boot]

Boot Type

8.3.15.0

8-3-16-0

8-3-16-0[boot]