Dell Force10 MXL Blade Посібник - Сторінка 23

Переглянути онлайн або завантажити pdf Посібник для Перемикач Dell Force10 MXL Blade. Dell Force10 MXL Blade 27 сторінок. 10/40gbe blade switches
Також для Dell Force10 MXL Blade: Посібник для початківців (38 сторінок), Примітка до заявки (6 сторінок), Технічні характеристики (2 сторінок)

Stacking Dell Force10 MXL 10/40G Switches

Proceed to copy the file [confirm yes/no]: yes

9582 bytes successfully copied

Synchronizing data to peer Stack-unit

!!!!

....

FTOS#reload

Once the reload has completed, unplug stacking cables from all ports where stacking was removed.

Renumbering stack units

Renumbering a Master, Standby or member unit, requires the stack-unit renumber command and a

reload of one or more switches:



Renumbering the Master switch requires a reload of the entire stack



Renumbering the Standby switch only requires that switch to reload, but a different member

switch is elected as the new Standby



Renumbering a member switch requires a reload of that switch only



Renumbering any unit in the middle of a daisy-chain topology stack may require a stack-split

and subsequent stack-merge to occur



Renumbering a switch to a number already assigned to another stack unit results in following

error message:

"Renumbering will reset the unit. Warning: Interface configuration for current unit will be

lost! Proceed to renumber [confirm yes/no]:"

Use the following command to renumber:

FTOS#stack-unit 1 renumber 5

Renumbering will reset the unit. Proceed to renumber [confirm yes/no]:

If the new number which we want to assign is already used by an existing member of the stack, the

below error will occur.

FTOS#stack-unit 1 renumber 5

% ERROR: stack unit 5 already exists.

If the new number assignment is already used by a logically provisioned unit in the stack, the below

confirmation message to overwrite is displayed.

FTOS#stack-unit 1 renumber 5

Stack unit 5 has configuration data. Overwrite? [confirm yes/no]:

Caution: Renumbering stack units may hinder management scripts and monitoring software that

collects data based on particular port traffic. Use renumbering with caution when monitoring ports

and be aware that scripts and monitoring parameters may need to be modified.