Dell PowerSwitch E3200-ON Series Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Dell PowerSwitch E3200-ON Series. Dell PowerSwitch E3200-ON Series 10 сторінок.
Друкувати сторінку
These instructions explain the external power supply (EPS) installation for the Dell PowerSwitch N2200-ON and N3200-ON/
E3200-ON full-width and half-width switches. You can use the optional EPS on a desktop, wall mount, or in a rack.
● The model name of the EPS Shelf with one PSU is MPS-1S.
● The model name of the EPS Shelf with three PSUs is MPS-3S.
NOTE:
For switch installation instructions, see the switch-specific Dell PowerSwitch Installation Guide at
support.
Regulatory models
● Model number E51W
● RTN: E51W001 for one slot
● RTN: E51W003 for three slots
Document revision history
Table 1. Revision history
Revision
Date
A02
2022-09
A01
2021-04
A00
2020–01
Topics:
•
Desktop mount
•
MPS-1S two-post installation
•
MPS-3S two-post installation
•
MPS-1S wall mount
•
Important information
Desktop mount
To use the EPS on a desktop, first attach the four small rubber feet to the underside of the switch.
1. Locate the four rubber feet shipped with the EPS.
2. Remove the paper backing on the bottom of one of the rubber feet.
3. Adhere the rubber foot to one of the four round position marks on the underside of the switch.
4. Repeat the process for the remaining three rubber feet.
N-Series EPS installation
Description
Updated to include the E3200-ON Series switches.
Minor corrections to the MPS-1S wall mount section.
Initial release.
www.dell.com/
N-Series EPS installation
1
3