Miele PW 6241 Інструкція з експлуатації Посібник з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Пральна машина Miele PW 6241. Miele PW 6241 46 сторінок.
Також для Miele PW 6241: Інструкція з експлуатації та монтажу (44 сторінок), Інструкція з експлуатації та монтажу (44 сторінок), Інструкція з програмування (48 сторінок)
Друкувати сторінку
Function buttons
Pressing the button activates the function
and pressing the button again deactivates it.
f Stop/End
The function button on the right-hand side is
used to stop a programme after it has
started.
Pressing it again finishes the programme.
+i Block plus
The relevant programme block (e.g.
Pre-wash) is added to the programme.
m
Starch stop
Press this button if you wish to laundry to be
starched.
k Without spin
Press this button if you do not want the
laundry to be spun after being rinsed.
FC Settings
Press this button to switch to another
language temporarily.
m Start time
Press this button before the start of a
programme to display the message that a
start time can be selected.
K Information
Press this button to call up programme
information in the display.
q Water drainage
i Manual control
See the programming instruction booklet.
Change order
ü The order of the programme in progress
can be changed or programme blocks can
be repeated.
A Back
Takes you back to the previous display.
e/- Indicates more information on the next
/ previous line
S Save
See the programming instruction booklet.
M.-Nr. 06 572 495
Description of the machine
$ Programme locked
Once a locked programme has been
started, the End button can only be used to
stop and cancel it during the first minute.
)
Programme unlocked
ß
Dispensing
ä
Dispensing switched off
\
Operating data
> I < 0- Setting (calibration)
If the display does not show 00.0 when the
drum is empty press this button to reset it.
D Data transfer
Chip card operation
The chip card is supplied without any
programmes.
See the programming instruction booklet for
information on transferring data from the
control unit to the chip card and vice versa.
A chip card is available to order as an
optional extra. It can store a maximum of 30
programmes, each with 6 blocks. The back
of the chip card can be labelled.
11