365SMART SM-02-02900 Посібник - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник для Шліфувальна машина 365SMART SM-02-02900. 365SMART SM-02-02900 20 сторінок. Drywall sander

Друкувати сторінку

8. PREPARATION FOR OPERATION

Assembly

CAUTION

Carry out all preparatory

operations with the device disconnected from

the power supply.

Out of the box, the device requires few assembly

steps.

• Use the adapter (no. 16) and suction hose (no. 15)

to connect the grinder outlet (no. 10) to the dust bag

(no. 14).

• Attachment of side handle.

Tighten the side handle (no. 17) into the body of the

grinder by turning clockwise. The side handle can be

mounted in two positions, on the left and right side of

the grinder.

• Mounting of abrasive paper.

When attaching the sandpaper to the sanding pad,

make sure the holes in the paper are aligned with the

holes in the pad to ensure effective dust extraction.

Press lightly on the sandpaper to secure it to the

sanding pad. The abrasive disc is fastened to the head

with Velcro. Once this has been done, the device is

ready for use.

Operation of the device

The best sanding results on dry gypsum surfaces are

achieved using 120-240 grit sandpaper.

Selection of paper grit to suit the type of work being

carried out:

Grit

Purpose

For removing significant surface

irregularities

For removing minor surface irregularities

For removing paint and glue

For smoothing

100

For pre-grinding

120

For grinding

150-180

For grinding fast drying surfaces

240

9. OPERATION

• Before starting work, make sure the work surface is

free of obstructions such as nails or screws. If

necessary, remove them.

• Hold the grinder with one hand on the main handle

and the other hand on the surface of the side

handle.

• Switch on the device by pressing the switch on the

handle of the device (Fig. no. 8) and wait until the

grinder is running at full speed, then place it on the

work surface. After starting the device, in order to

avoid the necessity of holding the start trigger all

the time, the lock button (Fig. 9) should be pressed

to ensure that the operation is maintained, then the

start trigger button (Fig. 8) should be released.

• The device is equipped with a speed regulation

knob (Fig. 6), regulation from 1-5 (where 1 is the

lowest speed and 5 the highest). This allows you to

continuously adjust the speed from 1400 to 2700

rpm. This makes it possible to adapt the rotational

speed to the grade of abrasive paper being used.

When working, select the speed with the knob

according to the principle "the finer the paper, the

higher the speed".

• Replace sandpaper when worn. Start with finer grit

sandpaper and finish with a fine pour pattern. Any

replacement of sandpaper must be carried out with

the machine plug disconnected from the power

socket!

• The device has the possibility of illuminating the

work area. Use the on/off switch (Fig. 12) to turn the

LED lighting on/off.