Install GCEMS software.
To take advantage of all new features, it is recommended that the latest version of GCEMS
software be installed on the GCEMS Server. The most current software can be obtained from
the Dialogic Technical Support website.
1. Go to the Dialogic Support Technical Website at
2. Select 'Downloads'. You will require a logon username and password to access the
downloads site. (A support contract is needed to access this site.) Within this site will
be two software binary files with the following format. Download the latest version of
these files.
•
IMG_10.5.3.xxx.bin
•
IMGUserInterface_10.5.3.xxx.bin
Note: If you do not have a support contract with Dialogic, then the software supplied
to you on the Software CD can be used.
1. Open a terminal on the GCEMS server and become a root/superuser by entering the
command:
[localuser@localhost]$ su
Password: excel2
Change the mode to executable for the following files being installed. This is
2.
accomplished by executing the following commands:
[root@localhost]#chmod +x IMG_10.5.3.xxx.bin
[root@localhost]#chmod +x IMGUserInterface_10.5.3.xxx.bin
3. Install GCEMS software.
[root@localhost]# ./IMG_10.5.3.xxx.bin (xxx=build)
The GCEMS will be installed in the directory/opt/dialogic/installs/IMG_10.5.3.xxx. At
the end of the installation you will be prompted to log out and then log back in. Do not
log out and back in at this time.
4. Install the IMG User Interface
[root@localhost]# ./IMGUserInterface_10.5.3.xxx.bin (xxx=build) (Follow prompts)
IMGUserInterface is installed into /opt/dialogic/installs/IMGUserInterface_10.5.3.xxx
directory.
5. At the end of the installation you will be prompted to log out. Log out as root user by
entering the exit command.
For more information on installing GCEMS and ClientView, refer to the IMG 1010 - Software
Installation and Setup > Installing GCEMS software topic in the online documentation
through the links above.
IMG 1010 Quick Start Guide
http://www.dialogic.com/support
(Follow prompts)
17
Друкувати сторінку