Allpro APS2730H Інструкція з ремонту та перелік деталей - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з ремонту та перелік деталей для Мийка високого тиску Allpro APS2730H. Allpro APS2730H 16 сторінок.

Pressure Relief

Follow these instructions whenever you are instructed to relieve pressure,

stop spraying for more than 10 minutes, check or service the equipment,

or install or clean the spray nozzle.

1. Engage trigger safety latch.

2. Turn Pressure Washer off and remove ignition cable

from spark plug.

3. Shut off water supply. Disconnect from water.

4. Remove trigger safety latch and trigger gun to

relieve pressure. Then engage the safety latch.

Note: If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after

following this procedure, disengage trigger safety latch and trigger gun again.

309887