Aquant BWT Series Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Системи фільтрації води Aquant BWT Series. Aquant BWT Series 14 сторінок. Top-mount sand-filter for swimming pool

Друкувати сторінку

ENGLISH

Once in the filter, the water is circulated downwards

through silica sand and suspended particles are retained.

The filter sand needs to be washed at intervals to remove the particles it has

retained backwash.

This is achieved by reversing the flow through the filter and directing the

water containing the dislodged particles to drain.

When the filter pressure reaches over 1.3 kg/cm², it means that the sand

filter needs to be backwashed.

Bearing these principles in mind, the following installation and operation

instructions should not represent any problem.

INSTALLATION

The filter should be installed as close as possible to the swimming pool and

preferably at a level of 0.50 metres below the surface of the water in the

swimming pool. Make sure there is drainage available at the place where the

filter is to be installed.

IMPORTANT: Do not use an iron and hemp pipe for the selector valve

connection, it is essential to use plastic accessories and TEFLON tape. Pipe

terminals are available threaded fixing in 1 ½ and 2".

Always leave enough space around the filter in order to perform the necessary

examinations and maintenance during the filter's life.

ASSEMBLY

Follow these indications for a correct assembly of the filter:

1.- Place the filter on a horizontal and clean surface.

2.- Place the filter in its final location.