Aquant BWT Series Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для Системи фільтрації води Aquant BWT Series. Aquant BWT Series 14 сторінок. Top-mount sand-filter for swimming pool

Друкувати сторінку

1.- Take off the clamp and the valve with the gasket.

2 - Cover the opening of the inner pipe in order not to drop sand inside it.

3.- Fill the filter with water to half capacity.

4.- Pour the required quantity of sand inside the filter.

5.- Clean the seating of the gasket joint.

6.- Fix the filter valve in place.

FILTRATION PROCESS

The selector valve has a handle of 6 positions that selects any of the

necessary operations to obtain the maximum efficiency from the filter.

IMPORTANT: Always switch off the pump, when changing the position

of the selector valve.

FILTRATION

With the pump switched off, place the handle of the

selector valve in the" FILTRATION" position.

Switch on the pump.

During this operation, it is advisable to observe the

pressure gauge from time to time as this indicates the

degree of saturation of the filter. When the pressure

reaches 18.5 PSI a "BACKWASH" should be carried out.

The main drain and skimmer valves will be regulated

according to the quantity of floating material found on

the surface of the water. Bear in mind that with the main

drain valve fully open there will be little suction from the

skimmers. If the surface sweep of the skimmers is to be

stronger, reduce the flow from the main drain.

ENGLISH

FILTER-FILTERN

FILTRATION

FILTRACION

FILTRAZION