Miller XT30i Посібник користувача - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller XT30i. Miller XT30i 44 сторінки.

Друкувати сторінку

5-5. Electrical Service Guide

Failure to follow these electrical service guide recommendations could create an electric shock or fire hazard. These recommenda-

tions are for a dedicated circuit sized for the rated output and duty cycle of the plasma cutter.

Input Voltage (V)

Input Amperes (A) At Rated Output

Max Recommended Standard Fuse Rating In Amperes

Min Input Conductor Size In mm

Max Recommended Input Conductor Length In Meters

Min Grounding Conductor Size In mm

Elec Serv 2011−08

5-6.

Selecting Extension Cord (Use Shortest Cord Possible)

When calculating max. cord length, remember to include conductor length from line disconnect device to input power receptacle.

Single Phase AC

Input Voltage

230 VAC

*Conductor size is based on maximum 3% voltage drop

5-7. Connecting Input Power

Installation must meet all National

and Local Codes − have only

qualified

persons

make

installation.

Special installation may be required

where gasoline or volatile liquids

are present − see NEC Article 511 or

CEC Section 20.

OM-256 118 Page 18

A complete Parts List is available at www.MillerWelds.com

The Auto-Line circuitry in this unit

automatically links the power source to

this

the primary voltage being applied.

See rating label on unit and check input

voltage available at site.

Conductor Size − mm

1.5

Maximum Allowable Cord Length in meters

Power Cord

Receptacle (Customer Supplied)

Connect plug to receptacle.

50/60 Hz Single Phase

230

14.3

A 10 ampere individual

circuit protected by

time-delay fuses or circuit

breaker is required.

See Section 4-1

1.5

Ref. 257 916-A