Miller 1009728 Інструкція користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція користувача для Засоби безпеки Miller 1009728. Miller 1009728 48 сторінок. Single anchor point

Once the job is finished, unhook your connector. Pull on the QUICKLOCK trigger to deblock the cone and withdraw your

apparatus. If the QUICKLOCK remains blocked, introduce a thin metallic rod and tap gently to push the blocking cone

backwards.

Min. thickness of support

Drilling diameter

Min. drilling depth

CLEARANCE

Before each use, make sure there is sufficient clearance under the user's feet to avoid collision with the structure or

the ground. Considering a 100 kg weight and a fall factor of 2 (least favourable case), clearance D is arrest distance

H (2L+1.75m) plus an additional distance of lm. (except in particular cases: see specific manual). When possible, the

Quicklock located above the user will minimize the height of the free fall.

PERIODIC EXAMINATION

These instructions must be kept with the product. Fill in the identification sheet while entering information about mark-

ing. This periodic examination is designed to check the efficiency and strength of the equipment and is indispensable to

protect the user. This equipment must be examined at least once a year, by a competent person and in strict compliance

with the manufacturer's instructions; the verification to be recorded on the attached sheet and by placing a sticker on

the product The frequency of the examination may need to be increased according to the regulations,for intensive use

or under harsh environmental conditions. The product markings must be legible.

MAINTENANCE AND CLEANING:

Protect from any heat source. Protect against chemical products which can harm the removable anchor. Protect against

sharp edges, rubbing and shocks during use and transport Clean with compressed air. Store away from light and sig-

nificant heat sources.

FIELD OF UTILISATION:

• HIGH LEVEL WORK

• HORIZONTAL SURFACE

CORRECT

SETTING DATA

110

Embedding depth

Min. interaxial between 2 anchor points

Min. distance between free edge and anchor point

• VERTICAL SURFACE

• INCLINED SURFACE

INCORRECT

188

155