AquaPower AP40RP Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Фільтр для басейну AquaPower AP40RP. AquaPower AP40RP 16 сторінок. Aquapower salt water chlorinator
Друкувати сторінкуCONTROL PANEL BUTTONS
MODE BUTTON:
Press to select ON, OFF or AUTO operation. (When
AUTO mode is selected, the ON/OFF times you have set
will switch both pump and chlorinator on and off on a daily
basis.)
OFF MODE:
Indicated by way of the anti-clockwise rotation of the top
portion of the first digit.
Neither pump or chlorinator will operate.
ON MODE:
Indicated by way of the clockwise rotation of the top
portion of the first digit.
Pump and chlorinator will operate continuously.
AUTO MODE:
Indicated by way of the clockwise rotation of the lower
portion of the first digit. While in the auto mode and
during an OFF time period, the display will alternate from
displaying OFF to displaying the next ON time. This
feature allows for an easy visual of when the unit will next
switch on.
VIEW BUTTON:
Press repeatedly to display, current time, %chlorine output
and all four ON/OFF periods. All values remain displayed
for 30 sec, the normal real time %chlorine output is then
displayed.
Current 24hr. time is displayed.
% Chlorine output, is displayed. Use UP/Down buttons to alter time
ON1 is displayed, wait to see ON1 time. Use UP/Down buttons to alter time
OFF1 is displayed, wait to see OFF1 time. Use UP/Down buttons to alter time
ON2 is displayed, wait to see ON2 time. Use UP/Down buttons to alter time
OFF2 is displayed, wait to see OFF2 time. Use UP/Down buttons to alter time
ON3 is displayed, wait to see ON3 time. Use UP/Down buttons to alter time
OFF3 is displayed, wait to see OFF3 time. Use UP/Down buttons to alter time
ON4 is displayed, wait to see ON4 time. Use UP/Down buttons to alter time
OFF4 is displayed, wait to see OFF4 time. Use UP/Down buttons to alter time
6
Wiring instructions for AquaPower-Plus
Above Ground Units Only
All AquaPower-Plus above ground chlorinator systems are
set up to operate at 110 volt only. (If 220 volt system is
needed please contact Aquapower-Plus)
110 Volt Wiring ( No internal wiring is needed)
1. Plug supplied power cord attached to unit, into GFCI
protected circuit.
2. Plug your 110 volt pump into the receptacle located
on unit.
Wiring of unit is complete. You just have to set your
AquaPower timer to appropriate settings as indicated in your
owner's manual.
23