AquaPower AP40RP Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Фільтр для басейну AquaPower AP40RP. AquaPower AP40RP 16 сторінок. Aquapower salt water chlorinator

Друкувати сторінку

Above Ground Installation Instructions

You're above ground AquaPower-Plus Salt Water Chlorinator requires

very little installation and should not require professional installation.

If however you do want professional installation please contact us for

assistance.

Without optional A-Frame Stand.

1. Remove unit and electrode from box.

2. If you have not purchased the optional stand than you must

mount your power pack in a suitable location (fence, post, block

wall, etc.) in close proximity to your existing pool equipment.

3. Mount the mounting bracket in appropriate location using the

supplied screws and anchors.

4. After hanging the power box. You may proceed to the cell

installation.

5. You may either run pvc piping to cell or use your existing

plastic hoses.

6. Your cell must be installed after your pool heater or ﬁlter.

(The last component before water enters your pool)

7. After cell is plumbed in refer to wiring instructions in your manual.

With optional A-Frame Stand

1. Remove unit and electrode from box.

2. Set up stand as with stand instructions.

3. Hang the power box on the hanging bracket included with the

AquaPower-Plus unit.

4. Set the cell on the u-brackets below the power box.

5. Turn off your valves to your pool equipment or plug openings in

side of pool so water will not discharge during installation.

6. Remove the plastic hose from your return ﬁtting at the pool, and

reattach to the large side (inlet) of your AquaPower-Plus. Fasten

with a stainless steel clamp.

7. Using the supplied plastic tube, fasten the tube to discharge end

of cell. Then fasten the other end to your pool return ﬁtting that

you disconnected in step 6.

8. Open the valves you have closed our remove the plug installed

and check for any leaks. If leaking tighten down your ﬁttings.

9. Add necessary salt per instruction manual directly to the

pool water.

10. Refer to wiring instructions to complete your installation.

UP/DOWN BUTTONS:

These are used to adjust the percent of chlorine level

output either during a real time display or if the view

button has been used to display the programmed

percent of chlorine output. They are also used to alter

the time periods displayed by the View button.

(The initial push of an UP/DOWN button will initiate the

set mode and the display will begin to ﬂash. Further

pushes will alter the display).

POWER PACK CONTROL PANEL

OPERATIONAL UNDERSTANDING

On start-up, power is ramped up to the cell after a 10 second delay. At the end

of a time period, the cell will cease production 30 seconds before the pump

switches off. This delay allows the system to ﬂush the pipe work and prevent

heavily chlorinated water diffusing through and damaging heater tube bundles.

When 100% chlorine output is set, full power is delivered to the cell, however

not for the entire ON time period. The cell power cycles on and off to achieve the

percentage chlorine output required. The power modulation can be witnessed by

observing the gas production at the cell.