Burley 1800 Посібник з монтажу та експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Внутрішній камін Burley 1800. Burley 1800 8 сторінок. Electric fire

Assembling the appliance

The appliance has been supplied with washed coal to create a realistic looking fuel bed, should you prefer to

add a small amount of sticks, pine cones or shells to enhance the appearance this is acceptable although

nothing should extend higher than 50mm up the screen. See the pictures below.

· Lay the fire on its back and place approximately 30 pieces of coal of varying sizes carefully on the

mirrored screen where it meets the orange coloured shell. Do not allow the coal to go near to the top

of the screen where pieces could fall in and obstruct the fan.

· Carefully unpack the glass screen and slide it in the gap beneath the canopy.

· Once it is sufficiently inserted rest the lower edge of the glass on the coal.

Unpacking and installing the appliance

Open the packaging carefully and remove the appliance. Keep the original

packaging for future transport.

The mains cable, plugs into the socket on the under-right hand side of the

back of the trim. Never use an extension lead. Take the mains cable through

one of the cut outs at the sides or rear, ensuring that it is not trapped. The

mains cable must remain at the back of the appliance and must not be in

contact with any hot elements.