Burley 1800 Посібник з монтажу та експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Внутрішній камін Burley 1800. Burley 1800 8 сторінок. Electric fire

To operate the appliance

Once the appliance has been securely fixed as above, plug the appliance into a 13amp wall socket. This must be a mains

socket, not a socket intended for lighting.

Pressing the top switch will turn on the main flame effect.

Pressing the middle switch will cause the flickering flame effect under the coal bed to come on. If the switch is

turned off and back on again the quick flickering will become a slow pulsing light, if the switch is turned off and

on again the pulsing will cease and the light will stay on constantly, turning the switch off and on again will take

it back to a flickering effect. When the fire is turned on it always starts with the flickering effect. The first two

switches will operate independently so you can have just the flame effect, just the flickering effect, or both.

The lower switch turns on the heater, the heater will ONLY work when the first switch is turned on. With the first

switch on, press the lower switch and turn the thermostat dial in a clockwise direction to maximum, the heater

will come on.

Thermostat.

The thermostat automatically turns the heater on and off according to room temperature. To set it, leave it fully on, and

when the room reaches the desired temperature, slowly turn it anti-clockwise until the heater clicks off. It will then

maintain this temperature by modulating on and off as the room cools and warms. The thermostat turns the heater

completely on or off. You do not get 70% of the heat on number 7 and 30% on number 3.

Cleaning the exterior of the appliance

Before cleaning the appliance, disconnect it from the socket and leave to cool.

You can clean the exterior of the appliance with a soft, damp cloth.

Do not use cleaning or polishing products.

Measurements (excluding trim and front)

Units: mm