AQUASTREAM ABSC02782 Посібник з монтажу, експлуатації та технічного обслуговування - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та технічного обслуговування для Інвертор AQUASTREAM ABSC02782. AQUASTREAM ABSC02782 20 сторінок.

Друкувати сторінку

Residential Steambath Generator Systems

5. R oute the end of the temperature probe cable with the

temperature probe through the wall into the steam room

as shown in Diagram 3.

Do not strain, staple, pinch or

IMPORTANT NOTE:

otherwise damage the probe cable.

6. With a minimal length of the cable exposed apply sili-

cone (provided) to the hole in the wall as required to

create a moisture seal as shown in Diagram 3.

7. Push the temperature cable and bulb into hole as

required to leave minimum 1/4 in. (6mm), maximum

1/2 in. (13mm) of the bulb exposed as shown below.

warning

Insure a minimum of 1/4 in. (6mm) of

the temperature bulb is exposed to the air. Failure to do so

may result in an inoperative control and a hazardous condi-

tion.

warning

The exposed area of the temperature

bulb must be free of silicone or any materials that prevent

direct exposure to the steam room air. Failure to do so may

interfere with the ability to sense temperature and may

result in excessive steam room temperatures.

1 ⁄2" (13 mm)

minimum

3 ⁄4" (90 mm)

maximum

Wall

SECTIONAL VIEW

S team R oom Interior

Diagram 3

Diagram 4

Silicone Sealant

Cable

INSTALLED REMOTE

TEMPERATURE PROBE

aquabrass.com