AQUASTREAM ABSC02789 Посібник з монтажу, експлуатації та технічного обслуговування - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та технічного обслуговування для Інвертор AQUASTREAM ABSC02789. AQUASTREAM ABSC02789 20 сторінок.

Друкувати сторінку

L oc a t i n g t h e St e a m Ge n e r a t or U n i t

Select a location as near as practical and outside the steam room. Typical locations include: closet, vanity

cabinet, heated attic or basement.

1. Locate steambath generator within 25 feet (7.6 m) of steam room.

2. Do not install steambath generator inside steam room.

3. Do not install steambath generator outdoors or wherever environmental conditions may affect the safety

and/or performance of the generator.

4. Do not install steambath generator or plumbing lines in unheated attic or any locations where water

could freeze.

5. Do not install steambath generator near flammable or corrosive materials or chemicals such as gasoline,

paint thinners, or the like. Installation in areas having high concentrations of chlorine (such as pool

equipment room) must be avoided.

6. Install steambath generator on a solid and level surface. Keyhole slots are provided on for wall mounting.

Insure the steam generator is properly secured and level when mounting with keyhole slots.

7. Install steambath generator in an upright position only.

8. Install anti-water hammer device as necessary.

9. Provide a minimum of 12 inches (30cm) at both ends and top of the steam generator or as required for

servicing. See page 6.

10. Provide unions as required to facilitate installation and disconnection of piping.

11.

I MPORTA N T :

operation and remain hot after shutdown for a period of time. Provide appropriate protection, including

insulating plumbing lines. Avoid plumbing runs and steamhead locations that can come in contact with

bathers, wiring and control cables.

aquasteam

12.

controls can be located inside or outside of the steam room The temperature sensor must

always be placed in the steamroom.

w a r n i n g

Aquasteam steam generators are for residential use only . Commercial or other non-residential

applications void the warranty and may adversely affect product performance. Use only aquasteam

series controls.

Ty pi c a I a q u a ste a m i n st a l l a ti o n

For illustrative purposes only.

N o t e :

Consult with qualiﬁed designer, architect or

contractor for steam room construction details.

Field installed

power supply

Steam Generator

Provideunions asrequired to facilitate

installtion and disconnect of piping

Steam line, safety valve, drain valve, plumbing and steamheads become hot during

Control Cable

Field

installed

water

supply pipe

Field

Valve is

installed

shown open

steam

supply pipe

Re s i de n t i a l St e a m ba t h Ge n e r a t or Sy s t e m s

Steam Head

(shown with available acrylic shield)

In-Shower

Control

Temperature s

IMPORTANT: See pg. 5 & pg.11

for steam head and temperature

sensor location information.

aquabrass.com