Diamond H2O Reliant DRS4-EM-66 Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Диспенсер для води Diamond H2O Reliant DRS4-EM-66. Diamond H2O Reliant DRS4-EM-66 19 сторінок. Reliant drs4 series single tank water softener

Друкувати сторінку

2. Place the tanks near a water source.

A. Select a position near a floor drain that has adequate carrying capacity to handle the

backwash flow rate. Refer to the specification Table in Section 8 for the appropriate flow rate.

B. Place the softener(s) and brine tank on a level, firm foundation, like concrete.

C. Determine the "front" of each tank received. For each tank:

a. Make sure that the distributer riser is flush with the top of

the resin tank.

b. Before placing any water, gravel, or resin in the resin tank,

screw in a control valve to the point where it is secure. The

valve does not need to be forced on, but should be snug.

c. The two tanks should be placed next to each other, with the

brine tank off to the side. The correct distance between the

two tanks can be determined by connecting the MAV to

both valve outlets.

d. Mark the "front" of each resin tank (shown in Figure 7) with

either a marker or tape. The front of the resin tank is

determined by the location of the face of the control valve

once it has been secured to the face of the control valve.

Make sure that the system is positioned in a way that the

plumbing can be installed.

D. Before Filling the Tanks:

e. Remove the valve(s)

f. Ensure that the front(s) of the tank(s) is/are positioned correctly. Once filled, the resin

tanks will be very difficult to move.

g. Cover the exposed end of the distributor riser(s) to make sure no resin gets inside. Covering

up the riser(s) with duct tape is one option, shown in Figure 8.

h. Obtain a funnel to assist placing the resin in the resin tanks. (A funnel designed specifically

for our resin tanks can be ordered from Diamond H2O Conditioning. The part numbers for

the two types of funnels are table 3.)

3. Setting up the tank:

A. Fill the tank up to 30% full of water.

B. Check the system specifications on page 2 to determine the correct amount of resin needed

for your system.

C. Position the distributor tube so it is in the center of the tank, shown in Figure 9. The

distributor tube should sit about an inch higher than the tank.

Mark w/ Tape

Front

Figure 7: Front of tank

Figure 8: How to Block

Distributer Tube

Figure 9: Centered Distributer Tube

pg. 3