Aquatech Pressmain MG-LT Інструкція з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Блок управління Aquatech Pressmain MG-LT. Aquatech Pressmain MG-LT 20 сторінок. Tankmatic tank level/temperature monitoring/control unit with smart relay control
Друкувати сторінку
2.3.2.2 To access the stop/set parameters/clock menu
to access the stop/set parameters/clock menu etc,
press the <ESC> key and <up arrow> key at the same time
Or,
press the <down arrow> repeatedly ,(this scrolls through any fault
messages) until the clock is displayed.
Note: to get to the clock, it may require pressing <left> or <right> arrows
if Inputs, Outputs, Markers or Cursor are displayed!
Inputs >
I
0....123456789
1...0123456789
2...01234
When the clock is displayed press <ESC> key. The stop/set parameters/clock
Menu is now displayed. Note: if the clock is not set then it will flash.
The time/date is retained for approximately 80 hours during power down.
2.3.2.3 To identify the Program Name
to identify the program name, access the stop/set parameters/clock menu
as above, then press the <down arrow> until the cursor points to ">Prg Name"
then press the <OK> key to display program name. Press <ESC> repeatedly
until the clock is again displayed, followed by the <up arrow> to return to the
main system screen.
2.3.2.4 To Stop/Start the Program Running
to stop/start the program running, access the stop/set parameters/clock menu
as above, then press the <down arrow> until the cursor points to ">Stop"
Then press <OK> and select "Stop Prg" >Yes <OK>.
to start program press the <down arrow> repeatedly until the cursor
points to ">Start". Then press <OK>
2.3.2.5 To set or view the parameters
to set or view the parameters, access the stop/set parameters/clock menu
as above, then press the <down arrow> until the cursor points to ">Set Param"
Please note: The screens shown on the unit are dependent on the unit type,
i.e. 1 or 2 tanks, Level and/or Temperature etc.
Aquatech‐Pressmain Instruction manual\Tankmatic smart relay MG‐LT
Outputs >
Q
0....123456789
1...0123456
Markers >
M
0....123456789
1...0123456789
2...01234
Tankmatic Smart Relay
Press V to
Clock then
ESC for Stop/
Params Menu
Mo 08:15
2003‐09‐22
Cursor >
ESC+C
^
< >
v
>Stop
Set Param
Set Clock
Prg Name
Stop
Set Param
Set Clock
>Prg Name
A11064 Iss. 5
MG1‐LT
>Stop
Set Param
Set Clock
Prg Name
Program
Card
Clock
>Start
Stop
>Set Param
Set Clock
Prg Name
15