aQuatell Fleck 5600SXT Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15 сторінок.

Once all of the resin has been added it is

very important to remove the piece of tape

from the top

of the riser tube.

Next, secure the upper media screen to the bottom of the water softener valve. The upper media

screen is a about three inches in length and is cylinder shaped. Depending on the type of

softener you ordered, the media screen may be white, black, or red:

There is an opening on both ends of the upper media screen. With the larger opening facing the

underside of the softener valve, press and turn the upper media screen so that it locks into place.

Once this is complete, ensure that the top lip and the threads of the softening tank are free from

resin. Apply a small amount of silicone lubricant (vegetable oil can be substituted) to the top

surface of the threads of the softening tank, to the o-ring on the underside of the softener valve,

and to the outer side of the top of the riser tube.

Lower the softener valve onto the softening tank making sure that the riser tube passes through

the upper media screen. Once the valve is lowered onto the tank, turn the valve in a clockwise

direction (as viewed from above). It is very important to exert force only on the valve and not on

the controller (at the front of the valve) during this step. Continue turning the valve until some

Page 4

Fleck 5600SXT U.S. V1.1