DIAVITE AG DIAVITE Compact VH Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Вимірювальні прилади DIAVITE AG DIAVITE Compact VH. DIAVITE AG DIAVITE Compact VH 14 сторінок.

Друкувати сторінку

Operation

2.1

Measuring

2.1.1 Start measuring operation

The area to be measured on the work piece must be properly cleaned in order to avoid that the

tracer is getting dirty. If the roughness is measured manually, the tracer is laid onto the work piece and

held steadily. At the lowest margin of the display, the position of the feeler can be controlled with the

arrow (↑). The ideal setting is reached when this sign appears in the centre of the display: →←. After

pressing the start key, the measuring procedure is effected automatically. In course, the measuring

values can be read on the LCD-display and printed out.

Pressing any key can interrupt a current measuring operation and bring the tracer to a halt. Actuate

the start button once more, to bring the tracer to its starting position again.

If the tracer is not in correct position, the measuring procedure can be released nevertheless!

2.1.2 Maximum measuring value

The maximum amplitude of the diamond stylus is 200 µm. If this is exceeded, there will be no

signal of faulty measurement. However, such high measuring values will always be indicated by the

arrow (↑), which means that the measuring results could be faulty.

2.1.3 Special tracers (probes)

Complementary to the standard tracer, there are a number of special tracers at disposal. These are

constructed to solve specific measuring problems and can be used only together with the measuring

stand.

2.1.2 Maximum measuring value

The maximum amplitude of the diamond stylus is 200 µm. If this is exceeded, there will be no

signal of faulty measurement. However, such high measuring values will always be indicated by the

arrow (↑), which means that the measuring results could be faulty.

2.1.3 Special tracers (probes)

Complementary to the standard tracer, there are a number of special tracers at disposal. These are

constructed to solve specific measuring problems and can be used only together with the measuring

stand.

Tracers without skid can be used only with the traverse unit VHF

The traverse unit must be set parallel to the measured surface.

When lowering the tracer onto the work piece, the 0-point of the feeler must be adjusted

exactly. The arrow indicates the direction, to which the tracer must be moved:

Taster

DIAVITE COMPACT

On the display, the arrow is situated on the left

margin and shows downwards

Carefully lower the tracer, until the pointer moves

from the left margin towards the centre.

If the correct zero point is reached, two arrows

appear in the middle of the indicator screen.

Push the key 'M' and start the measuring

operation.

If the sensor is set too deep, the arrow appears on

the right half of the display

upwards. The tracer must be set in a

higher position

ATTENTION, the tracer might be damaged!

and shows