DieHard Portable Power 1150 Посібник оператора - Сторінка 17
Переглянути онлайн або завантажити pdf Посібник оператора для Пульт дистанційного керування DieHard Portable Power 1150. DieHard Portable Power 1150 17 сторінок. Diehard portable power 1150 battery charger operator's manual
Також для DieHard Portable Power 1150: Посібник користувача (11 сторінок), Посібник оператора (16 сторінок), Посібник оператора (15 сторінок), Посібник оператора (12 сторінок)
Друкувати сторінку
PROBLEM
The jump starter won't
power my 12v device.
The battery in the jump
starter won't hold a charge.
The jump starter alarm is
on.
12.
SPECIfICATIONS
Internal Battery Type
Nominal voltage
Capacity
DC Power Outlet (Max. Continuous Load)
Built-in Work Light (Non-replaceable)
Jumper Cables
Dimensions (H x W x D)
Product Weight
Maximum Continuous Power
Surge Capacity (Peak Power)
No Load Current draw
Wave Form
Input voltage Range
AC Outlets
13.
REPLACEMENT PARTS/ACCESSORIES
Air Compressor Accessory Kit (3 Hose Adaptors) --------------------00-99-000599
Inflator Accessory Kit: (Inflator / Deflator Hose, Unit End and 3 Hose Adaptors)
--------------------------------------------------------------------------------------00-99-000598
Male-to-Male Accessory 12v Charging Connector ----------------------- 94500109
POSSIBLE CAUSE
The 12v device is not
turned on.
The jump starter battery is
not charged.
The 12v device draws more
than 15A or has a short
circuit
The battery is bad (will not
accept a charge).
Connections are reversed.
Maintenance-free AgM Lead-acid
12v dC
22 Ah
15A (both outlets combined)
Two, 5w/12v dC (Base type BA9S)
4-gauge AWg, 24 Inches
12 H x 11.5 x 10.5 Inches
24.5 lbs.
AC Power Specifications
400 Watts
800 Watts
<0.3 Amps
Modified Sine Wave
10.5 - 15.5v dC
Two, 120v AC 3-Prong NEMA 5-15
14
•
•
REASON/SOLUTION
Turn on the 12v device.
Check the battery charge
status by pressing the
button on the front of the
jump starter. See dIgITAL
dISPLAY FUNCTIONS
section of this manual.
disconnect the 12v device.
The internal breaker will
automatically reset after a
minute or two. Try the 12v
device again. If it happens
again, replace the 12v
device.
Have the battery checked.
disconnect the jump starter
and reverse the clips.