DieHard Portable Power 1150 Посібник оператора - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник оператора для Пульт дистанційного керування DieHard Portable Power 1150. DieHard Portable Power 1150 17 сторінок. Diehard portable power 1150 battery charger operator's manual
Також для DieHard Portable Power 1150: Посібник користувача (11 сторінок), Посібник оператора (16 сторінок), Посібник оператора (15 сторінок), Посібник оператора (12 сторінок)
Друкувати сторінку
3.
fOLLOW THESE STEPS WHEN CONNECTINg TO A BATTERY
3.1
Attach the output cables to the battery and chassis as indicated below. Never
allow the output clips to touch each other.
3.2
Position the dC cables to reduce the risk of damage by the hood, door and
moving or hot engine parts. NOTE: If it is necessary to close the hood during
the charging process, ensure that the hood does not touch the metal part of
the battery clips or cut the insulation of the cables.
3.3
Stay clear of fan blades, belts, pulleys and other parts that can cause injury.
3.4
Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery post
usually has a larger diameter then the NEGATIVE (NEG, N, -) post.
3.5
Determine which post of the battery is grounded (connected) to the chassis.
If the negative post is grounded to the chassis (as in most vehicles), see step
3.6. If the positive post is grounded to the chassis, see step 3.7.
3.6
For a negative-grounded vehicle, connect the POSITIVE (RED) clip from the
jump starter to the POSITIVE (POS, P, +) ungrounded post of the battery.
Connect the NEGATIVE (BLACK) clip to the vehicle chassis or engine block
away from the battery. do not connect the clip to the carburetor, fuel lines or
sheet-metal body parts. Connect to a heavy gauge metal part of the frame or
engine block.
3.7
For a positive-grounded vehicle, connect the NEGATIVE (BLACK) clip from
the jump starter to the NEGATIVE (NEG, N, -) ungrounded post of the battery.
Connect the POSITIVE (RED) clip to the vehicle chassis or engine block away
from the battery. do not connect the clip to the carburetor, fuel lines or sheet-
metal body parts. Connect to a heavy gauge metal part of the frame or
engine block.
3.8
When disconnecting the jump starter, turn all switches to off (if applicable),
remove the clip from the vehicle chassis and then remove the clip from the
battery terminal.
NEgATIvE gROUNDED SYSTEM
•
A SPARK NEAR THE BATTERY
MAY CAUSE A BATTERY
EXPLOSION. TO REDUCE THE
RISK Of A SPARK NEAR THE
BATTERY:
4
•