Olympus BH2-CH Substage Збірка - Сторінка 11

Переглянути онлайн або завантажити pdf Збірка для Мікроскоп Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 сторінок.

Figure 22 – Remove the stop-pin spring from the slide

Reassemble the Condenser-Height Stop

Use a 1.5mm Allen wrench or driver to back out the

M3x4 stop-pin set screw so that the threads do not

protrude into the bore in the condenser slide (see

Figure

23).

Figure 23 – Back out the stop-pin set screw from the slide

Use a cotton swab and a suitable solvent (e.g., acetone)

to thoroughly clean the stop pin and the bore of the

condenser slide. Test the fit of the stop pin in the bore.

The pin should slide freely in the bore without any

noticeable friction or binding (see

Figure 24 – Test the fit of the stop pin in the bore

It is critical to the operation of the condenser-height

stop that this pin move freely in the bore in the

condenser slide. If there is noticeable friction or any

binding present, use a .1990" (i.e., 5.05mm) twist drill

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

24).

bit to clean the bore of any debris or internal burring

(see

Figure

25).

Figure 25 – Clean any debris or burring from the bore

Place the stop-pin spring into the bore in the condenser

slide (see

Figure

26).

Figure 26 – Reinstall the stop-pin spring into the bore

Place the M5x12 stop pin into the bore in the condenser

slide (see

Figure

27).

Figure 27 – Reinstall the stop pin into the bore

Use a 1.5mm Allen wrench or driver to tighten the

M3x4 set screw to secure the stop pin in position (see

Figure

28).

Revision 1

Page 11 of 26