Olympus BH2-CH Substage Збірка - Сторінка 24

Переглянути онлайн або завантажити pdf Збірка для Мікроскоп Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 сторінок.

Use a 2.5mm Allen wrench or driver to reinstall three

M3x6 hex socket-head cap screws to secure the left-

hand dovetail block onto the main housing (see

100).

Figure 100 – Reinstall screws to secure left dovetail block

Apply a light coating of grease onto the inside beveled

bearing surfaces of the two dovetail blocks and onto the

two flat bearing surfaces of the main housing (see

Figure

101).

Figure 101 – Grease the bearing surfaces for the slide

Reinstall the Condenser-Slide Assembly

Apply a light coating of grease onto the flat bearing

surfaces of the dovetail slide (see

Figure 102 – Grease flat bearing surfaces of dovetail slide

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

102).

Apply a light coating of grease onto the two beveled

bearing surfaces of the dovetail slide (see

Figure 103 – Grease beveled surfaces of dovetail slide

Carefully engage the greased condenser slide with the

dovetail blocks on the main housing (see

Figure 104 – Engage condenser slide with dovetail blocks

Rotate the condenser-height knob counter-clockwise

until the hole in the condenser slide aligns with the

tapped hole in the main housing (see

Figure 105 – Align the hole in slide with the tapped hole

Use a suitable slotted screwdriver to reinstall the

M2.6x4 condenser-slide stop screw through the hole in

the condenser slide and into the tapped hole in the

main housing (see

Figure

103).

Figure

104).

Figure

105).

106).

Revision 1

Page 24 of 26