Olympus BH-NRE Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Лабораторне обладнання Olympus BH-NRE. Olympus BH-NRE 17 сторінок. Modular revolving nosepiece

onto the stationary base (see

loose protective cover from the turret assembly (see

Figure

5).

Figure 4 – Remove screws securing the cover in place

Figure 5 – Remove the protective cover

Figure 6 – The turret assembly (without cover)

Complete Teardown, Cleaning, and Reassembly of the Olympus BH-NRE Modular Revolving Nosepiece

Figure

4) and remove the

Remove the Dovetail Slide

The dovetail slide attaches to the stationary base of the

turret assembly via four M2.6X5 pan-head screws. Use

a suitable JIS screwdriver to remove these four M2.6X5

screws (see

Figure

7) and then remove the loose

dovetail slide from the stationary base (see

Figure 7 – Remove four screws securing the dovetail slide

Figure 8 – Remove the loose dovetail slide

The next step is to remove the mechanical detent stop

from the stationary base of the turret assembly. Use a

suitable JIS screwdriver to remove the two M2X4 pan-

head screws securing the detent stop to the stationary

base (see

Figure

9). Note that these screws are usually

staked in place with adhesive and can be surprisingly

stubborn to remove, so be sure to use the proper JIS

screwdriver to prevent damaging the screw heads. It

might also be helpful to heat the screws with a heat gun

before loosening them, and to apply a solvent (acetone)

to the threads as the screw is loosened.

Figure

8).

Page 6 of 17

Revision 3