Alpha-InnoTec SWC - Series Посібник з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Тепловий насос Alpha-InnoTec SWC - Series. Alpha-InnoTec SWC - Series 20 сторінок. Brine/water heat pumps
Друкувати сторінку
6
Installation and connection
6.1 Dismantle the module box
ATTENTION
If the module box is tilted by more than 45°,
compressor oil runs into the cooling circuit.
Do not tilt the module box by more than 45°.
NOTE
If necessary the module box can be
dismantled for easier transport of the unit
or for service reasons.
Steps 1 to 5 are only required if the
Unit is safely disconnected from the power
supply and protected against being switched
1.
Remove the front panel of the module box
(
"7.1 Remove the front panel of the module
box" on page 19).
2.
Close shut-off valves to the heating circuit.
3.
heating.
12
Subject to change without notice | 83056700dUK – Translation into English of the original German operating manual | ait-deutschland GmbH
Unit without cooling:
Unit with cooling:
NOTE
the shut-off valves to the heat source are
located at the top of the unit next to the
shut-off valves to the heating circuit.