Alpha-InnoTec SWC - Series Посібник з експлуатації - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Тепловий насос Alpha-InnoTec SWC - Series. Alpha-InnoTec SWC - Series 20 сторінок. Brine/water heat pumps
Друкувати сторінку
Mount the control on the wall and connect
1.
2.
If visually unattractive: Cut off the lugs on the
rear of the control (are only needed to insert in
the front panel).
3.
control,
4.
the web at the bottom in the middle of the wall
5.
plugs (1) and 2 screws" (3).
1.
2.
1
6.
Feed in the cables from the wall (e.g. in-wall
box) or from below.
7.
Route the LIN bus cable from the top right-hand
side at the rear from the heat pump and plug
into the control at the bottom.
8.
9.
(accessories).
Subject to change without notice | 83056700dUK – Translation into English of the original German operating manual | ait-deutschland GmbH
"Dimensioned drawing of
3.
4.
2
3
7
7.1
Remove the front panel of the
module box
Unscrew the front panel of the module box.
7.2 Heating water quality
NOTE
For detailed information refer, among
other things, to the VDI Guidelines
2035
"Vermeidung
Warmwasserheizanlagen"
damage in hot water heating systems).
Required pH value: 8,2 ... 10
for
aluminium
8,2 ... 8.5
Fill the system with deionised heating water
(VE water) only or VDI 2035 (low-salt operation
of the system).
von
Schäden
in
(preventing
materials:
pH
value:
19