Alpha-InnoTec SWC - Series Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Тепловий насос Alpha-InnoTec SWC - Series. Alpha-InnoTec SWC - Series 20 сторінок. Brine/water heat pumps
Друкувати сторінку
Cooling
Cooling is integrated in type K units. Type H units
accessories. The following options are possible for
units with cooling function (
the heating and heat pump controller):
Passive cooling (without compressor)
Control of the cooling function via the heating
and heat pump controller
Switching
between
mode; automatically with expansion board
(accessories)
The control can be connected to a computer or
pump controller can then be controlled from the
4
Operation and care
NOTE
The unit is operated via the control of
the heating and heat pump controller
(
operating manual of the heating and heat
pump controller).
4.1 Energy and environmentally
aware operation
The generally accepted requirements for energy-
aware and environmentally-aware operation of a
heating system also apply to use of a brine/water
heat pump. The most important measures include:
No unnecessarily high domestic hot water
temperature (note and follow local regulations)
Do not open windows with gap /tilt open
(continuous ventilation), but instead open wide
for a short time (purge ventilation).
4.2 Maintenance
Wipe down the outside of the unit only using a damp
cloth or cloth with mild cleaning product (washing-
up liquid, neutral cleaning product). Do not use any
harsh, abrasive, acid or chlorine-based cleaning
products.
Subject to change without notice | 83056700dUK – Translation into English of the original German operating manual | ait-deutschland GmbH
operating manual of
heating
and
cooling
5
Delivery, storage, transport
and installation
ATTENTION
Damage to the housing and the unit components
due to heavy objects.
Do not place any objects on the unit which are
heavier than 30
5.1 Scope of supply
NOTE
On delivery the accessories are enclosed in
outwardly visible damage and completeness.
Notify supplier of any defects immediately.
page 3 of this manual
Control unit, consisting of the control, wall
6-mm anchors with screws (2x each) for wall-
mounting the control unit
Safety valve, outdoor sensor
Insulation material for venting valve on the cold
exchanger
Handle for cooling drain tap
Replacement material after dismantling the
module box:
– Insulation hoses (2x)
– Cable ties (4x)
–
–
O-rings (8x)
–
–
9