Axminster ujk 106843 Посібник - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник для Інструменти Axminster ujk 106843. Axminster ujk 106843 20 сторінок. Universal dovetail jig

THROUGH DOVETAILS

• Max timber width - 300mm

• Min timber thickness - 10mm

• Max timber thickness - 19mm (pin board)

Parts needed -

• Template A (through / box)

• 10.79mm Straight cutter (pins)

• 13.55mm Dovetail cutter (dovetails)

• ⅝" (15.9mm) Guide bush (pins)

• ¾" (19mm) Guide bush (dovetails)

All boards are cut vertically

Cut dovetails first - dovetail cutter, ¾" guide bush used

1) Attach comb A with the straight fingers (tails) at the

front of the jig, see fig 01 & level the comb by placing

a 15-20mm thick x 150mm - 200mm wide x 200mm -

250mm long flat board underneath the comb locking

the comb in place using the comb lock knobs, see fig 02.

Fig 01-02

2) Move the magnetic extraction then use the hex key

provided to move the side stop to the left, see fig 03-04-

05. Load in vertically the first board on the left of the jig

pushing up to the underside of the comb & centralising

to the fingers, see fig 06-07.

25mm (tail board)

Fig 03-04-05

Fig 06-07

3) Ensure that the material markers on the comb are

centralised to the top of the board & look equal along the

length, see fig 08.

Fig 08

4) Slide the side stop towards the right to make contact

with the side of the board, see fig 09 & lock in place.

Fig 09

5) Use the opposing board to mark a cutter depth set

line on the material, see fig 10 then plunge the dovetail

cutter down through the fingers in front of the board so

that the tip of the cutter just meets the marked line, see

fig 11.

Equal distance

Side Stop