Axminster ujk 106843 Посібник - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для Інструменти Axminster ujk 106843. Axminster ujk 106843 20 сторінок. Universal dovetail jig

Fig 10-11

6) Slide or reattach the extraction, see fig 12 on

the right & begin the cut working from left to right

ensuring that the router stays flat on the comb at all

time, see fig 13. Use the guide lines to help find the

fingers, see fig 14 DO NOT LIFT THE ROUTER WHILST IT

IS RUNNING!

Fig 12-13-14

Guide line

Cutting pins - 10.79mm straight cutter, ⅝" guide bush

used

1) Undo the 4 countersunk hex screws & turn the comb

around so that the V shape fingers are at the front of

the jig (pins), see fig 15-16-17-18. Load in vertically the pin

board against the left hand side stop & up against the

underside of the comb, see fig 19-20. Undo the comb lock

knobs & use the comb adjuster knob to align the finger

line to the edge of the board, see fig 21-22.

Fig 15-16-17-18

Fig 19-20

Fig 21-22

2) Use the opposing board to mark a cutter depth set

line on the material, see fig 23 then plunge the straight

cutter down through the fingers in front of the board so

that the tip of the cutter just meets the marked line, see

fig 24.

Fig 23-24

3) Reposition the magnetic extraction, see fig 25 on the

left & begin the cut working from left to right, see fig 26-

27. DO NOT LIFT THE ROUTER WHILST IT IS RUNNING!

THROUGH DOVETAILS

Continues over...