AXTON A200 Посібник з монтажу та експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Підсилювач AXTON A200. AXTON A200 17 сторінок. 1-/2-/4-/5-channel power amplifiers
Друкувати сторінкуThank you for purchasing this AXTON amplifier!
To maximize the performance of this amplifier and your complete car audio system install, we
recommend that you acquaint yourself thoroughly with all technical features and controlling
options of this AXTON amplifier. Please read this manual carefully, before attempting the
installation.
If, after reading this manual, you still have questions regarding functions or the installation of
the amplifier, we recommend that you consult your dealer.
1. CONNECTIONS + CONTROLS A100 - PAGE I
1
SIGNAL INPUTS R / L
Low-level stereo RCA signal or high-level speaker signal input terminal for connection to
head-unit.
2
AUTO-TURN-ON MODE
Slide switch to select the auto-turn-on function: REM by remote wire, VOX to switch on
by music signal or DC by DC offset signal of the head units integrated amplifier.
3
INPUT GAIN CONTROL
Input gain potentiometer for the subwoofer output channel, to match the output voltage
of the head unit to the amplifier's input.
4
SUBSONIC HIGHPASS FREQUENCY CONTROL
Control potentiometer to adjust the subsonic highpass filtering frequency point of the
subwoofer output channel.
5
BASS BOOST 0dB to + 18dB
Turn clockwise to get up to + 18dB bass boost or counterclockwise for no boost with a
45 Hz center frequency of the amplified output signal.
6
LOWPASS FREQUENCY CONTROL
Control potentiometer to adjust the lowpass filtering frequency point of the subwoofer
output channel.
7
BASS LEVEL REMOTE CONTROL INPUT 1/2-CH
Input terminal to connect the external bass level remote to the amplifier.
8
POWER LED
LED to show the operating status of the amplifier by blue/red illumination. Blue is
normal working state, red is protect mode of amplifier.
9
INPUT MODE SELECTION
Switch to select the proper input sensitivity range: RCA signal input = Low. Speaker
signal input = Hi.
10 SPEAKER OUTPUT TERMINAL
Output terminal to connect the speakers to the amplifier.
11 "+12 V" POWER INPUT TERMINAL
Terminal to connect the amplifier to the positive +12V pole of the car battery.
12 "REM" INPUT TERMINAL
Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the
head unit. By using the REM terminal, you need to switch the Auto-turn-On mode
the "REM" position.
– 2 –
1. CONNECTIONS + CONTROLS A100 - PAGE II
13 "GND" POWER INPUT TERMINAL
Terminal to connect the amplifier to the chassis ground or negative pole of the car
battery.
1
to
2
2 3
4
5
6
105.0 mm
9
bl
bm
bn bo
– 3 –
7
8