Epson 1160 CFS Інструкція з монтажу Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Принтер Epson 1160 CFS. Epson 1160 CFS 12 сторінок.

See the photo below to determine which color goes into which chamber. You must

not make a mistake on this, it is vital to be correct. Use a felt tip pen and label

each chamber with the correct letters.... K, C, M, Y.

Do not remove foil pull tabs from top of cartridges.

ARC-SO20089-E = ARC-SO20191-E

Follow these steps for each chamber, starting with Black.......

A) Use the Bottom Fill Adapter and puncture the clear seal over the exit port for the

color you are about to inject. Only puncture the one you are going to put ink into.

B) Unwrap the syringe, remove the protective cap, and attach a green needle to the end

of the syringe. Twist it on with your fingers, so it is tight.

Make sure the syringe plunger is down all the way, then insert the tip of the needle

into the ink and pull ink into the syringe. Pull in a 1/2 to 1 cc more than is shown in

the table above. (For the black you will have to do this in two steps, 11 cc , and 11 cc

more).

Hold the syringe, needle pointed up, and remove the needle and attach the Bottom

Fill Adapter.

S a v e

M o n e y

MIS Associates Inc

http://www.inksupply.com

Color

Black

Cyan

Magenta

Yellow

a n d

I m p r o v e

2901 Auburn Rd

Fax: 248-289-6013

Volume (cc)

This is important.

ARC-SO20108-E = ARC-SO20189-E

Y o u r

Auburn Hills, MI 48326

P r i n t i n g

800-445-8296