Epson 1400 CFS Інструкція з монтажу Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Принтер Epson 1400 CFS. Epson 1400 CFS 15 сторінок.

Place the bottles on the right side of the printer in the order shown above

Before trimming each tube and connecting them to the fittings on the bottles, double

check that your bottles and tubes are in the proper color order.

Recheck proper tube color of tubes coming as they come out of the Beige Clip

The tube lengths will need to be trimmed so that the tube will connect to the fitting on

top of the bottle without having a large amount of slack. The best way to accomplish this

is to pull the tube over next to the bottle and mark the tube with a ball point pen at the

point where the tube and the bottom of the bottle cap meet.

Set up the bottles as shown, and work with one tube at a time, starting with the magenta

tube. Test the length of this tube by placing it near the bottle, on the outside, and see if

it is going to reach the bottom of the bottle cap. It should not be too short. If it looks

like it is going to be too long, then mark the tube with a ball point pen at the spot you

think it should be cut.

Remove the white plug from the end of the tube and cut the tube with scissors where you

placed the mark. After cutting the tube immediately connect it to the bottle. SAVE

THE WHITE PLUGS as they will be needed if you ever remove the CFS System from your

printer.

Make sure the correct color tube goes onto the correct color ink bottle. A mistake here

will ruin the whole system and you will need to purchase an empty cartridge set w/ tubes.

S a v e

M o n e y

a n d

I m p r o v e

Y o u r

P r i n t i n g

MIS Associates Inc

2901 Auburn Rd

Auburn Hills, MI 48326

800-445-8296

http://www.inksupply.com

Fax: 248-289-6013