Epson 570e - LQ B/W Dot-matrix Printer Інформаційний посібник про продукт - Сторінка 14
Переглянути онлайн або завантажити pdf Інформаційний посібник про продукт для Принтер Epson 570e - LQ B/W Dot-matrix Printer. Epson 570e - LQ B/W Dot-matrix Printer 18 сторінок. Warranty statement
Також для Epson 570e - LQ B/W Dot-matrix Printer: Короткий довідник (15 сторінок), Технічні характеристики (2 сторінок), Обмежена гарантія (1 сторінок)
Друкувати сторінку
EPSON LQ-570e
If you use the push tractor, you can use the tear-off feature to
advance your continuous paper to the tear-off edge when you
finish printing. You can then easily tear off the printed
document. When you resume printing, the printer
automatically feeds the paper back to the top-of-form position,
saving the paper normally lost between documents.
You can use the tear-off feature manually by pressing the
button, or automatically by turning on the auto
tear-off mode.
If the perforation between pages is not aligned with the tear-off
edge, you can adjust the position of the perforation using the
micro adjust feature.
After your document prints, check that the Tear Off/Bin lights
are not flashing. Then press the
Off/Bin lights start flashing and the paper advances to the tear-
off edge.
To automatically advance your printed documents to the tear-
off position, you need to turn on the auto tear-off mode and
select the appropriate page length for continuous paper in the
default setting mode. For instructions, see "Changing Default
Settings" on page 15.
When auto tear-off is on, the paper automatically advances to
the tear-off position when the printer receives a full page of data
or a form feed command followed by no more data.
If the paper perforation is not aligned with the tear-off edge,
you can use the micro adjust feature to move the perforation to
the tear-off position. Follow the steps below.
1. Make sure the Tear Off/Bin lights are flashing (the paper
is at the current tear-off position). If necessary, press the
button to advance the paper to the tear-off
position.
14 - EPSON LQ-570e
2. Open the paper guide cover.
3. Hold down the
4. Press the
button. The Tear
5. After you set the tear-off position, press the
6. Tear off the printed page(s).
When you resume printing, the paper automatically feeds back
to the top-of-form position and printing begins.
1. Turn off the printer.
2. If a single sheet of paper is stuck on the paper guide, gently
3. Remove the printer cover. If continuous paper from the rear
4. If continuous paper is jammed in the printer, tear off the
5. Turn the knob away from you to eject the paper in the
4/00
button for about 3 seconds. The
Pause light begins flashing and the printer enters the micro
adjust mode.
D button to feed the paper backward, or
U button to feed the paper forward
press the
until the paper perforation is aligned with the tear-off edge.
to turn off the micro adjust mode.
remove it.
slot is loaded in the printer, remove the paper guide.
supply at the perforation nearest the paper entry slot.
printer. Remove any remaining pieces of paper.
tear-off edge
button