DigiDesign FWx FireWire Посібник - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник для Обладнання для запису DigiDesign FWx FireWire. DigiDesign FWx FireWire 18 сторінок.
Друкувати сторінкуChapter 3: Using FWx
Overview
Using FWx, you can record and archive performances, and
you can integrate pre-recorded Pro Tools tracks with live in-
puts. By combining these recording and playback features,
you can also perform Virtual Soundchecks by playing back
tracks you recorded earlier.
Signal routing for recording and playback using FWx is done
in both Pro Tools and in D-Show.
D-Show Signal Routing
FWx Outputs (Recording)
FWx provides 18 assignable outputs for recording D-Show
channels into Pro Tools.
For information on assigning D-Show channels for recording,
see "D-Show Signal Routing for FWx Recording" on page 11.
FWx Inputs (Playback)
FWx provides 18 assignable inputs for playback of Pro Tools
tracks through your system.
For information on assigning Pro Tools tracks for playback in
D-Show, see "D-Show Signal Routing for FWx Playback" on
page 13.
Pro Tools Settings
The connection to the FWx card is reflected in the Pro Tools
Hardware Setup dialog, and FWx inputs and outputs appear in
the Pro Tools I/O Setup dialog. This allows you to assign track
inputs and outputs to FWx.
When using FWx, Pro Tools session bit depth and sample
rate are fixed at 24-bit/48 kHz, and cannot be changed.
For complete information on configuring your Pro Tools
system, see the 003 & 003 Rack Getting Started guide or the
Pro Tools Reference Guide.
D-Show Signal Routing for FWx
Recording
You can assign any mono or stereo D-Show channel to FWx
channels, including channel Direct Outputs, Mains, Auxes,
mono or stereo Groups, Matrix outputs, and PQ outputs. Use
the Patchbay>Outputs page to route D-Show output busses or
Direct Outputs to FWx channels 1-18 for recording.
Using Direct Outputs lets you record discrete channels from
the pickoff point you choose.
Using Mains, Aux, Group, Matrix, or PQ outputs lets you
record a stereo main mix, one or more stereo submixes, or any
combination of these, up to the number of available FWx
channels.
If you configure the Patchbay for playback as well as
recording through FWx, be sure to check Pro Tools
track outputs for any potential feedback loops before
record enabling tracks.
To route multiple Direct Outputs to Pro Tools for a multitrack
recording:
In the D-Show Patchbay, click the Directs tab.
1
Click the tab at the left of the grid for the channel or bus
2
type you are routing.
Click the Pro Tools tab at the top right of the grid to show
3
the available FWx channels.
Chapter 3: Using FWx 11