DigiDesign FWx FireWire Посібник - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник для Обладнання для запису DigiDesign FWx FireWire. DigiDesign FWx FireWire 18 сторінок.

Друкувати сторінку
Click in the channel grid to assign a channel or bus (listed
4
on the left) to FWx channels (listed across the top).
Routing a Direct Output to an FWx channel
Activate and set the level for each Direct Output by clicking
5
its In button and dragging its on-screen encoder in the Direct
Out section.
Activating a Direct Output in the Directs page of the Patchbay
Click the Pickoff column in the Patchbay to specify one of
6
the following the pickoff sources for each Direct Output:
• top of channel (indicated by a "T")
• pre-fader (indicated by a lowercase "p")
• post-fader (indicated by an uppercase "P")
The available Direct Output pickoff points for Input
Channels and FX Returns can configured globally as
pre- or post-fader in the Options > Pickoffs page.
Click to display Pickoff menu
Specifying the channel Pickoff source
Configure Pro Tools tracks for multitrack recording.
7
12
FWx Record/Playback Option Card
To route the L/R main mix to Pro Tools for a stereo recording:
In the D-Show Patchbay, go to the Outputs page.
1
Click the Mains tab to the left of the channel grid.
2
Click the Pro Tools tab at the top right of the grid to show
3
the available FWx channels.
Click in the channel grid to route the Main Left and Right
4
outputs to FWx channels 1–2.
Routing the Mains bus to FWx channels for recording
Configure Pro Tools for stereo recording.
5
To use an Output bus to route a submix to Pro Tools:
In the D-Show Patchbay, go to the Outputs page.
1
Click the Mains, Aux, Group, Matrix, or PQ tab to the left of
2
the grid to display the type of bus you want to use.
Pickoff points for output busses in the Outputs tab are al-
ways post-fader. Use the Directs tab and select the pickoff
point to record output busses pre-fader.
Click the Pro Tools hardware tab at the top right of the grid
3
to show the available FWx channels.
Click in the grid to route busses (listed on the left) to FWx
4
channels (listed across the top).
D-Show software does not support using FWx channels for
insert processing through Pro Tools.
Configure Pro Tools for recording.
5