Digilin Colour Theme 1 Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Освітлювальне обладнання Digilin Colour Theme 1. Digilin Colour Theme 1 8 сторінок. Single channel dmx dimmer
Друкувати сторінкуColour Theme 1 - Single Channel DMX Dimmer
User Manual
7.1 - 17 September 2020
Installation
Wiring
The Colour Theme has a single 4 way screw terminal
block, as shown in Figure 1. This provides connections
for the power and data. The positive voltage input
should be between +12V and +24V. This cable can be
secured to the cable mount point using a cable tie.
If using the serial interface, connect the unit using a
null modem cable (refer to Appendix A. RS232 Null
Modem Cables Using RJ45 Connectors to see how
these cables are constructed) to the chosen host.
Mounting
The Colour Theme Controller is housed in a
standard Clipsal plate, and as such is compatible
with any standard mounting boxes or clips. There is also a mounting frame (Clipsal Part number 4000VH1)
available in 5 colours that can be used to cover the black base and compliment wall colour.
To install the Colour Theme Controller
1.
Remove the knob by gently pulling it straight back
2.
Remove the fascia by inserting a small flat blade screwdriver into the slots on the top and bottom
of the plate and lever it off.
3.
Mount to wall using appropriate hardware.
4.
Re-attach fascia by pushing it into place at the top then at the bottom.
5.
Re-install the knob by gently sliding it onto the shaft.
Operation
Software Version
On power up, the Colour Theme Controller will briefly display 2 codes. First it will briefly display -1-,
indicating that this is a 1 channel Colour Theme. Next it will display the firmware version.
Dimming
The Colour Theme 1 allows the light level to be dimmed from 100% to off in 5% steps. This is done by
turning the knob (clockwise to increase dim level, anti-clockwise to decrease it). The display will show the
current dim level until dimmed to off, at which point the display will turn off.
Switching Drivers Off
To turn off the LED light fittings, simply give a short press to the knob (less than 0.5 seconds). The unit will
then display OFF for a period of 10 seconds before the display goes blank.
While the Colour Theme Controller is off, any show running is paused. To turn the light fittings back on,
simply press the knob or turn it clockwise to increase the dim level.
digilin.com.au
+617 3899 1267
RJ45 serial
Cable
interface
Mount
connector
Point
V+ D+ D- Gnd
Figure 1 Connections on the Colour Theme Controller
Configuration
mode jumper
Page 4 of 8