Cresco 20S Посібник - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник для Розкидач Cresco 20S. Cresco 20S 18 сторінок. Fertilizer and salt spreader

Assembling your Cresco 20

Secure the lower linkage (22) in place using the

R pin small as shown.

NOTE

When placing the legs on the hopper, make sure

the two holes on the side of the lower frame

(Item 15) are on the outside. There should be one

hole on the inside.

Rotate the hopper body (17) to the position shown.

Place the gear box and impellor (4) in the centre

hole of the hopper body (17), let it rest there. Make

sure the arrow on the gearbox faces forwards. The

arrow should point away from the stand (2).

If at any point you become stuck, please refer to the video instructions-

https://crescospreaders.com/product/spreaders/estate/cresco-20sw

Take the two lower frames (15) and attach them

to the hopper body (17) using the M6x60 bolts

(10). SEE NOTE BELOW.

Take the stand (item 3) and place it into the

protruding M6x60 bolts (x4) (item 10). Tighten

with the M6 lock nuts (x4) (Item 11).

ASSEMBLING THE WHEELS:

Place one axle bearing (Item 5) into the hole

shown at the bottom of the lower frame (15).