Digimerge DPD24D Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Камера спостереження Digimerge DPD24D. Digimerge DPD24D 15 сторінок. Ultra resolution day & night dome camera
Також для Digimerge DPD24D: Інструкція з експлуатації (15 сторінок), Інструкція з експлуатації (14 сторінок)
Друкувати сторінку
INSTALLATION. VANDAL DOME
1
DPV24TLX ONLY
When using DC power, note the correct polarity stated on the
label attached to the power cord.
1) Remove the three tamper screws using the provided
Note: If you plan to use conduit fitting, remove conduit
Method 1 - Direct Attach Install
2
2a) Use included mounting template to mark and pre-
a
Remove (one base locking screw, used for shipping
Go to step
OR
Method 2 - Camera Base Install
Note: Use this method if installing onto junction box
2b) Remove the camera base by unscrewing the base
b
3
Note: If you plan on installing onto a junction
a
3a) Reinsert camera module into camera base
b
3b) Use the supplied three base locking screws to
Go to step
allen key. Size is standard T-15
cap using the prodivded conduit key.
drill the required holes. Use 2pc of the 2.8" screws
to mount the camera directly to the mounting
surface.
purposes) and install the 3rd 2.8" screw.
4
on page 7 to complete installation.
plate.
locking screw, and turn camera module approx. 5
degrees counter-clockwise to detach camera base
from the camera module. Now you install the base
to the correct holes as indicated on the mount
template using the 1.2" screws.
box, attach provided fitting plate first to
the junction box and then you attach the
camera base to the fitting plate.
by ligning up the arrow notches, and turning
camera module clockwise to lock into place.
secure camera base to camera module.
4
on page 7 to complete installation.
-6-
INSTALLATION. VANDAL DOME
4
4) Remove camera cover by squeezing the back and front
of the cover as indicated by the "PRESS" indicators at
the same time and lifting it up and away from the lens.
5
5) Insert the included video test cable into the RCA jack
and connect to a test monitor to set up camera.
6
6a) Adjust camera viewing angle and secure into place by
tightening thumb screw using a flat head screwdriver.
6b) Adjust lens and OSD as required.
6c) Re-attach the camera cover, using the thumb screw
as a guide, until it snaps into place.
Note: Lens adjustment levers are by default in the
locked position. Turn counter clockwise to unlock.
Tighten levers to secure lens setting.
7
7a) Re-attach the camera cover. Line up arrows as shown in
figure 3a on page 6 as a guide
7b) Use the allen key to tighten the tamper screws to create
a proper weatherproof seal.
Note: Make sure dome cover cord does not get caught in
the rubber seal.
-7-