Cisco 400 Series Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Перемикач Cisco 400 Series. Cisco 400 Series 8 сторінок. Fasthub
10/100 series
Також для Cisco 400 Series: Посібник з конфігурації (40 сторінок)
Друкувати сторінку
Connect the Hub to Other Network Devices
(continued)
Power outlet
rollover console cable
(Optional) Connect the
Console Cable
Make sure console port settings of the
1
FastHub 400M model match the
settings of the terminal, PC, or laptop.
The default settings of the hub console
port are 9600 baud, 8 data bits,
1 stop bit, no parity, and no flow
control.
Connect the rollover console cable to
2
the CONSOLE port on the hub.
Connect the other end of the rollover
3
cable to your terminal, PC, or laptop
(if necessary, use an appropriate
adapter, such as the supplied
RJ-45-to-DB-9 adapter).
From your terminal, PC, or laptop, start
4
the terminal emulation program.
RATING
CONSOL E
100-127 / 200-240 V~
2A /1A 50 / 60 Hz
Console port
RJ-45-to-RJ-45
(supplied)
DC INPUTS FOR REMOTE
POWER SUPPLY
UP
10/100 BASE-TX
SPECIFIED IN MANUAL
+5V
@
6A, +12V
@
1A
DC INPUT
STAT DUP 100
DOWN
MEDIA MODULE
(RJ-45)
RJ-45-to-DB-9
adapter (supplied)
Power Up the Hub
Connect one end of the power cord to
1
the hub and the other end to a power
source.
Note: You can use the internal power
supply and the Cisco 600W AC Redundant
Power System (RPS). Attach only the Cisco
RPS (model PWR600-AC-RPS) to the RPS
receptacle.
Wait approximately 2 minutes for the
2
hub to complete its power-on self-test
(POST).
After POST completes, the Continue
with configuration dialog? prompt
appears on the management station.
You can then follow the prompts to
assign IP information to the hub.
4