DIGISYSTEM VM-2000 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання DIGISYSTEM VM-2000. DIGISYSTEM VM-2000 2 сторінки.
Друкувати сторінку
Caution:
Always disconnect the power cord before troubleshooting.
Trouble
Instrument inoperative
Head doesn't rotate
Speed can't not be controlled
There is a big noise during
operation
The "TOUCH" function can't
work
DIGISYSTEM LABORATORY INSTRUMENTS INC.
Service Manual
Troubleshooting Guide
Cause
Power cord not connected to outlet.
Dead power output.
Defective electronic component.
Switch isn't at 'AUTO or "TOUCH' position.
Eccentric brass rod doesn't work well.
Switch is broken.
Motor is broken.
PC board is broken.
PC board is broken.
Speed controller is broken.
Eccentric brass rod doesn't work well.
Belt which is to fix the eccentric brass rod
doesn't work well.
Switch isn't at "TOUCH' position.
The starting button under the motor is broken. Contact your distributor for repair.
Plug in the power cord.
Change to different output.
Contact your distributor for repair.
Place the switch at 'AUTO or "TOUCH' position.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Contact your distributor for repair.
Place the Switch at 'TOUCH' position.
www.digisystemlab.com
Remedy
REV.2-2020